PLC and DTAM Software Programs for Pumping Instrumentation and Control Skid N

Koch, M. R.

CH2M Hill Hanford Group, Inc.

关键词: 99 General And Miscellaneous//Mathematics, Computing, And Information Science;    Waste Retrieval;    Measuring Instruments;    Documentation;    Computerized Control Systems;   

DOI  :  10.2172/801864
RP-ID  :  RPP-5492, Rev.0
RP-ID  :  AC27-99RL14047
RP-ID  :  801864

美国|英语

来源: UNT Digital Library

【 摘 要 】

This document describe the software programs for the Programmable Logic Controller and the Datable Access Module for Pumping Instrumentation and Control skid ''N''. The Appendices contains copies of the printouts of these software programs. This document describes the software programs for the Allen-Bradley SLC 500 programmable logic controller (PLC) and the Allen-Bradley DTAM PLUS operator interface module used on Pumping Instrumentation and Control (PIC) skid ''N''. The software programs for the SLC 500 and DTAM Plus are based on the core programs provided by Allen-Bradley. The PLC and DTAM software programs on skid ''D'' for SX-104 are the baseline programs. These baselines have been tailored for U-farm skids. The skid ''N'' program for U-109 is similar to the skid ''M'' program for U-102. An Acceptance Test Procedure (ATP) and an Operational Test Procedure (OTP) verify that the software programs meet the specific requirements for U-109 pumping. This document represents the final PLC and DTAM programs for PIC skid ''N'' at U-109. These programs were printed out after the performance of the OTP. The OTP acts as the final qualification test for the software programs. Functional requirements and details of the PLC ladder logic are described in this document. The final programs entered into the PLC and DTAM Plus are included as Appendices to this document.