OPTIMIZATION OF COAL PARTICLE FLOW PATTERNS IN LOW NOX BURNERS

Wendt, Jost O.L. ; Ogden, Gregory E. ; Sinclair, Jennifer ; Budilarto, Stephanus

National Energy Technology Laboratory (U.S.)

关键词: Diffusion;    Flow Rate;    Burners;    Aerodynamics;    01 Coal, Lignite, And Peat;   

DOI  :  10.2172/790986
RP-ID  :  FG26-97FT97269--04
RP-ID  :  FG26-97FT97269
RP-ID  :  790986

美国|英语

来源: UNT Digital Library

【 摘 要 】

It is well understood that the stability of axial diffusion flames is dependent on the mixing behavior of the fuel and combustion air streams. Combustion aerodynamic texts typically describe flame stability and transitions from laminar diffusion flames to fully developed turbulent flames as a function of increasing jet velocity. Turbulent diffusion flame stability is greatly influenced by recirculation eddies that transport hot combustion gases back to the burner nozzle. This recirculation enhances mixing and heats the incoming gas streams. Models describing these recirculation eddies utilize conservation of momentum and mass assumptions. Increasing the mass flow rate of either fuel or combustion air increases both the jet velocity and momentum for a fixed burner configuration. Thus, differentiating between gas velocity and momentum is important when evaluating flame stability under various operating conditions. The research efforts described herein are part of an ongoing project directed at evaluating the effect of flame aerodynamics on NO{sub x} emissions from coal fired burners in a systematic manner. This research includes both experimental and modeling efforts being performed at the University of Arizona in collaboration with Purdue University. The objective of this effort is to develop rational design tools for optimizing low NO{sub x} burners. Experimental studies include both cold-and hot-flow evaluations of the following parameters: primary and secondary inlet air velocity, coal concentration in the primary air, coal particle size distribution and flame holder geometry. Hot-flow experiments will also evaluate the effect of wall temperature on burner performance.