Bleach Plant Capital Reduction with Rapid DO Bleaching and Simplified (D/E/D) Stages

McDonough, T. J. ; Courchene, C. E. ; Baromes, J-C.

United States. Department of Energy. Idaho Operations Office.

关键词: Chlorine Dioxide;    Softwood;    Brightness;    Pulp;    Hardwood;   

DOI  :  10.2172/765310
RP-ID  :  DOE/ID/13562
RP-ID  :  FC07-97ID13562
RP-ID  :  765310

美国|英语

来源: UNT Digital Library

【 摘 要 】

The objective of this work was to demonstrate the capabilities of a bleaching sequence that combined a short retention time initial chlorine dioxide stage, referred to as rapid D0, (D0R), with simplified bleaching stages, (D1/E/D2), that required only one final bleach washer. The test sequence DR(EPO)(D/E/D/) was compared to a control sequence, D(EPO)D, for both hardwood and softwood pulps. The capabilities of the DR(EPO)(D/E/D) sequence were successfully demonstrated. An existing three- or four-stage bleach plan can be converted to the more powerful DR(EPO)(D/E/D) sequence without the major capital cost of additional washers. The results from this study showed that the DR(EPO)(D/E/D) sequence can reach 85 brightness on SW with 2.8% total C1O2, while the control sequence, D(EPO)D, required 3.9% C1O2. There was a corresponding decrease in AOX for the test sequence. The strength of pulp bleached in the test sequence was similar to or slightly higher than the control. For the HW pu lp, the test sequence reached 88 brightness with 2.2% C1O2 compared to 3.3% C1O2 for the control. There was a corresponding decrease in AOX generation with the lower chemical requirements. The final viscosity and pulp strength for the test sequence on HW was significantly higher than the corresponding values for the control sequence.