Protective coatings for concrete

NAGY, KATHRYN L. ; CYGAN, RANDALL T. ; BRINKER, C. JEFFREY ; SELLINGER, ALAN

Sandia National Laboratories

关键词: Cements;    36 Materials Science;    Dissolution;    Concretes;    Protective Coatings;   

DOI  :  10.2172/756038
RP-ID  :  SAND97-2940
RP-ID  :  AC04-94AL85000
RP-ID  :  756038

美国|英语

来源: UNT Digital Library

【 摘 要 】

The new two-layer protective coating developed for monuments constructed of limestone or marble was applied to highway cement and to tobermorite, a component of cement, and tested in batch dissolution tests. The goal was to determine the suitability of the protective coating in retarding the weathering rate of concrete construction. The two-layer coating consists of an inner layer of aminoethylaminopropylsilane (AEAPS) applied as a 25% solution in methanol and an outer layer of A2** sol-gel. In previous work, this product when applied to calcite powders, had resulted in a lowering of the rate of dissolution by a factor of ten and was shown through molecular modeling to bind strongly to the calcite surface, but not too strongly so as to accelerate dissolution. Batch dissolution tests at 22 C of coated and uncoated tobermorite (1.1 nm phase) and powdered cement from Gibson Blvd. in Albuquerque indicated that the coating exhibits some protective behavior, at least on short time scales. However, the data suggest that the outer layer of sol-gel dissolves in the high-pH environment of the closed system of cement plus water. Calculated binding configuration and energy of AEAPS to the tobermorite surface suggests that AEAPS is well-suited as the inner layer binder for protecting tobermorite.