Advanced CdTe Photovoltaic Technology: September 2007 - March 2009

Barth, K.

National Renewable Energy Laboratory (U.S.)

关键词: Efficiency;    14 Solar Energy;    Capacity;    Thin Films Solar Cells;    Apertures;   

DOI  :  10.2172/1013910
RP-ID  :  NREL/SR-5200-51517
RP-ID  :  AC36-08GO28308
RP-ID  :  1013910

美国|英语

来源: UNT Digital Library

【 摘 要 】

During the last eighteen months, Abound Solar (formerly AVA Solar) has enjoyed significant success under the SAI program. During this time, a fully automated manufacturing line has been developed, fabricated and commissioned in Longmont, Colorado. The facility is fully integrated, converting glass and semiconductor materials into complete modules beneath its roof. At capacity, a glass panel will enter the factory every 10 seconds and emerge as a completed module two hours later. This facility is currently undergoing trials in preparation for large volume production of 120 x 60 cm thin film CdTe modules. Preceding the development of the large volume manufacturing capability, Abound Solar demonstrated long duration processing with excellent materials utilization for the manufacture of high efficiency 42 cm square modules. Abound Solar prototype modules have been measured with over 9% aperture area efficiency by NREL. Abound Solar demonstrated the ability to produce modules at industry leading low costs to NREL representatives. Costing models show manufacturing costs below $1/Watt and capital equipment costs below $1.50 per watt of annual manufacturing capacity. Under this SAI program, Abound Solar supported a significant research and development program at Colorado State University. The CSU team continues to make progress on device and materials analysis. Modeling for increased device performance and the effects of processing conditions on properties of CdTe PV were investigated.