Development of a Low-Cost Particulate Matter Monitor

White, Richard M. ; Apte, Michael G. ; Gundel, Lara A. ; Black, Justin

关键词: ABSORPTION;    AEROSOLS;    CURRENTS;    DATA;    DEPOSITION;    DEPOSITS;    DETECTION;    EFFICIENCY;    ELEMENTS;    EQUIPMENT;    FIELD TESTS;    LICENSES;    MATTER;    MONITORS;    PARTICLES;    PARTICULATES;    POWER;    PUMPS;    RESONATORS;    SHIELDING;   

DOI  :  10.2172/979811
RP-ID  :  LBNL-2859E
PID  :  OSTI ID: 979811
Others  :  TRN: US201012%%1161

学科分类：能源（综合）

美国|英语

来源: SciTech Connect

【 摘 要 】

We describe a small, inexpensive portable monitor for airborne particulates, composed of the following elements: a. A simple size-selective inlet (vertical elutriator) that permits only particles below a pre-set diameter to pass and enter the measurement section; b. A measurement section in which passing particles are deposited thermophoretically on a micro-fabricated resonant piezoelectric mass sensor; c. An optical characterization module co-located with the mass sensor module that directs infrared and ultraviolet beams through the deposit. The emergent optical beams are detected by a photodiode. The optical absorption of the deposit can be measured in order to characterize the deposit, and determine how much is due to diesel exhaust and/or environmental tobacco smoke; and d. A small pump that moves air through the device, which may also be operated in a passive mode. The component modules were designed by the project team, and fabricated at UCB andLBNL. Testing and validation were performed in a room-sized environmental chamber at LBNL in to which was added either environmental tobacco smoke (ETS, produced by a cigarette smoking machine) or diesel exhaust (from a conventional diesel engine). Two pilot field tests in a dwelling compared the monitor with existing aerosol instruments during exposure to infiltrated ambient air to which cigarette smoke, diesel exhaust, wood smoke and cooking fumes were added. The limit of detection (LOD) derived from statistical analysis of field data is 18 mu g m-3, at the 99percent confidence level. The monitor weighs less than 120 g and has a volume of roughly 250 cm3. Power consumption is approximately 100 milliwatts. During this study, the optical component of the device was not fully implemented and has been left for future efforts. Suggested improvements in the current prototype include use of integrated thermal correction, reconfiguration of the resonator for increased particle collection area, increased thermophoretic collection efficiency using an increased temperature gradient, and shielding the resonator electronics from deposition of ultrafine particles.