Summary Report on New Transmutation Analysis for the Evaluation of Homogeneous and Heterogeneous Options in Fast Reactors

R. M. Ferrer ; S. Bays ; M. Pope ; B. Forget ; W. Skerjanc ; M. Asgari

关键词: ACTINIDES;    CONVERSION RATIO;    DIMENSIONS;    FAST REACTORS;    FISSION;    FUEL CYCLE;    HELIUM;    INVENTORIES;    NUCLEAR FUELS;    PLUTONIUM;    RECYCLING;    REPROCESSING;    SODIUM;    SYMMETRY;    TARGETS;    TRANSMUTATION;    WASTES;    WATER;    SPENT FUELS Minor Actinides;    Sodium Fast Reactor;    Targets;    Transmutation;    Transuranics;   

DOI  :  10.2172/938446
RP-ID  :  INL/EXT-08-14708
PID  :  OSTI ID: 938446
Others  :  TRN: US0806100

学科分类：核能源与工程

美国|英语

来源: SciTech Connect

【 摘 要 】

A 1000 MWth commercial-scale Sodium Fast Reactor (SFR) design was selected as the baseline in this scenario study. Traditional approaches to Light Water Reactor (LWR) Spent Nuclear Fuel (SNF) transuranic waste (TRU) burning in a fast spectrum system have typically focused on the continual homogeneous recycling (reprocessing) of the discharge fast reactor fuel. The effective reduction of transuranic inventories has been quantified through the use of the transuranics conversion ratio (TRU CR). The implicit assumption in the use of this single parameter is a homogeneous fast reactor option where equal weight is given to the destruction of transuranics, either by fission or eventual fission via transmutation. This work explores the potential application of alternative fast reactor fuel cycles in which the minor actinide (MA) component of the TRU is considered ‘waste’, while the plutonium component is considered as fuel. Specifically, a set of potential designs that incorporate radial heterogeneous target assemblies is proposed and results relevant to transmutation and system analysis are presented. In this work we consider exclusively minor actinide-bearing radial targets in a continual reprocessing scenario (as opposed to deep-burn options). The potential use of targets in a deep burn mode is not necessarily ruled out as an option. However, due to work scope constraints and material limit considerations, it was preferred to leave the target assemblies reach either the assumed limit of 200 DPA at discharge or maximum allowable gas pressure caused by helium production from transmutation. The number and specific design of the target assemblies was chosen to satisfy the necessary core symmetry and physical dimensions (available space for a certain amount of mass in an assembly based on an iterated mass density).