Girder Alignment Plan

Wolf, Zackary ; Ruland, Robert ; LeCocq, Catherine ; Lundahl, Eric ; Levashov, Yurii ; Reese, Ed ; Rago, Carl ; Poling, Ben ; Schafer, Donald ; Nuhn, Heinz-Dieter ; Wienands, Uli ; /SLAC

关键词: ACCURACY;    ALIGNMENT;    BEAM POSITION;    CALIBRATION;    EFFICIENCY;    MONITORS;    PHYSICS;    QUADRUPOLES;    TOLERANCE;    WIGGLER MAGNETS;   

DOI  :  10.2172/992866
RP-ID  :  SLAC-TN-10-040
PID  :  OSTI ID: 992866
Others  :  TRN: US1008029

学科分类：核物理和高能物理

美国|英语

来源: SciTech Connect

【 摘 要 】

The girders for the LCLS undulator system contain components which must be aligned with high accuracy relative to each other. The alignment is one of the last steps before the girders go into the tunnel, so the alignment must be done efficiently, on a tight schedule. This note documents the alignment plan which includes efficiency and high accuracy. The motivation for girder alignment involves the following considerations. Using beam based alignment, the girder position will be adjusted until the beam goes through the center of the quadrupole and beam finder wire. For the machine to work properly, the undulator axis must be on this line and the center of the undulator beam pipe must be on this line. The physics reasons for the undulator axis and undulator beam pipe axis to be centered on the beam are different, but the alignment tolerance for both are similar. In addition, the beam position monitor must be centered on the beam to preserve its calibration. Thus, the undulator, undulator beam pipe, quadrupole, beam finder wire, and beam position monitor axes must all be aligned to a common line. All relative alignments are equally important, not just, for example, between quadrupole and undulator. We begin by making the common axis the nominal beam axis in the girder coordinate system. All components will be initially aligned to this axis. A more accurate alignment will then position the components relative to each other, without incorporating the girder itself.