HTR-PROTEUS Pebble Bed Experimental Program Cores 1, 1A, 2, and 3: Hexagonal Close Packing with a 1:2 Moderator-to-Fuel Pebble Ratio

John D. Bess ; Barbara H. Dolphin ; James W. Sterbentz ; Luka Snoj ; Igor Lengar ; Oliver K??berl

关键词: BENCHMARKS;    BURNABLE POISONS;    CONFIGURATION;    CONTROL ELEMENTS;    GRAPHITE;    IAEA;    KINETICS;    MODERATORS;    MOISTURE;    PEBBLE BED REACTORS;    PHYSICS;    POLYETHYLENES;    PROTEUS;    REACTION KINETICS;    SAFETY;    STAINLESS STEELS;    VALIDATION;    WATER Benchmark;    HTR-PROTEUS;    IRPhEP;    Pebble Bed;    TRISO;   

DOI  :  10.2172/1042385
RP-ID  :  INL/EXT-11-23219
PID  :  OSTI ID: 1042385
Others  :  TRN: US1204680

美国|英语

来源: SciTech Connect

【 摘 要 】

In its deployment as a pebble bed reactor (PBR) critical facility from 1992 to 1996, the PROTEUS facility was designated as HTR-PROTEUS. This experimental program was performed as part of an International Atomic Energy Agency (IAEA) Coordinated Research Project (CRP) on the Validation of Safety Related Physics Calculations for Low Enriched HTGRs. Within this project, critical experiments were conducted for graphite moderated LEU systems to determine core reactivity, flux and power profiles, reaction-rate ratios, the worth of control rods, both in-core and reflector based, the worth of burnable poisons, kinetic parameters, and the effects of moisture ingress on these parameters. Four benchmark experiments were evaluated in this report: Cores 1, 1A, 2, and 3. These core configurations represent the hexagonal close packing (HCP) configurations of the HTR-PROTEUS experiment with a moderator-to-fuel pebble ratio of 1:2. Core 1 represents the only configuration utilizing ZEBRA control rods. Cores 1A, 2, and 3 use withdrawable, hollow, stainless steel control rods. Cores 1 and 1A are similar except for the use of different control rods; Core 1A also has one less layer of pebbles (21 layers instead of 22). Core 2 retains the first 16 layers of pebbles from Cores 1 and 1A and has 16 layers of moderator pebbles stacked above the fueled layers. Core 3 retains the first 17 layers of pebbles but has polyethylene rods inserted between pebbles to simulate water ingress. The additional partial pebble layer (layer 18) for Core 3 was not included as it was used for core operations and not the reported critical configuration. Cores 1, 1A, 2, and 3 were determined to be acceptable benchmark experiments.