Channeling through Bent Crystals

Mack, Stephanie ; /Ottawa U. /SLAC

关键词: ACCELERATORS;    BEAM DUMPS;    BENDING;    CHANNELING;    CRYSTAL LATTICES;    DETECTION;    FORTRAN;    METERS;    MULTIPLE SCATTERING;    NUCLEAR POTENTIAL;    PARTICLE BEAMS;    QUADRUPOLES;    REFLECTION;    STANFORD LINEAR ACCELERATOR CENTER Accelerators;    OTHER;   

DOI  :  10.2172/1050214
RP-ID  :  SLAC-TN-12-026
PID  :  OSTI ID: 1050214
Others  :  TRN: US1204684

学科分类：核物理和高能物理

美国|英语

来源: SciTech Connect

【 摘 要 】

Bent crystals have demonstrated potential for use in beam collimation. A process called channeling is when accelerated particle beams are trapped by the nuclear potentials in the atomic planes within a crystal lattice. If the crystal is bent then the particles can follow the bending angle of the crystal. There are several different effects that are observed when particles travel through a bent crystal including dechanneling, volume capture, volume reflection and channeling. With a crystal placed at the edge of a particle beam, part of the fringe of the beam can be deflected away towards a detector or beam dump, thus helping collimate the beam. There is currently FORTRAN code by Igor Yazynin that has been used to model the passage of particles through a bent crystal. Using this code, the effects mentioned were explored for beam energy that would be seen at the Facility for Advanced Accelerator Experimental Tests (FACET) at a range of crystal orientations with respect to the incoming beam. After propagating 5 meters in vacuum space past the crystal the channeled particles were observed to separate from most of the beam with some noise due to dechanneled particles. Progressively smaller bending radii, with corresponding shorter crystal lengths, were compared and it was seen that multiple scattering decreases with the length of the crystal therefore allowing for cleaner detection of the channeled particles. The input beam was then modified and only a portion of the beam sent through the crystal. With the majority of the beam not affected by the crystal, most particles were not deflected and after propagation the channeled particles were seen to be deflected approximately 5mm. After a portion of the beam travels through the crystal, the entire beam was then sent through a quadrupole magnet, which increased the separation of the channeled particles from the remainder of the beam to a distance of around 20mm. A different code, which was developed at SLAC, was used to create an angular profile plot which was compared to what was produced by Yazynin's code for a beam with no multiple scattering. The results were comparable, with volume reflection and channeling effects observed and the range of crystal orientations at which volume reflection is seen was about 1 mrad in both simulations.