Effect of applied pressure on microstructure development and homogeneity in an aluminium alloy processed by high-pressure torsion

JOURNAL OF ALLOYS AND COMPOUNDS

卷:688

Article

Bazarnik, Piotr¹  Romelczyk, Barbara¹  Huang, Yi²  Lewandowska, Malgorzata¹  Langdon, Terence G.^2,3,4 

[1] Warsaw Univ Technol, Fac Mat Sci, Woloska 141, PL-02507 Warsaw, Poland

[2] Univ Southampton, Fac Engn & Environm, Mat Res Grp, Southampton SO17 1BJ, Hants, England

[3] Univ Southern Calif, Dept Aerosp Mech Engn, Los Angeles, CA 90089 USA

[4] Univ Southern Calif, Dept Mat Sci, Los Angeles, CA 90089 USA

关键词: Al-Mg alloy;    Applied pressure;    Grain refinement;    High-pressure torsion;    Microhardness;   

DOI  :  10.1016/j.jallcom.2016.07.149

来源: Elsevier

【 摘 要 】

An investigation was conducted to evaluate the influence of applied pressure on the processing of an aluminium 5483 alloy by high-pressure torsion (HPT). Discs were processed by HPT through 1/4 to 5 revolutions at room temperature using the two different applied pressures of 1.0 and 6.0 GPa. Samples were examined after HPT using microhardness measurements and transmission electron microscopy. Colour-coded maps were constructed to show the hardness distributions and the mechanical properties were evaluated by tensile testing. It is shown that the results are dependent upon the applied pressure such that a higher pressure enhances the accumulation of defects and leads to a more rapid grain refinement. The effect of pressure is especially visible in the early stages after fractional numbers of turns since the microstructure and properties tend to homogenize at high numbers of turns. (C) 2016 Elsevier B.V. All rights reserved.

【 授权许可】

Free