Effect of mechanical milling on the harmonic structure development during spark plasma sintering of Ti-5Al-2Sn-4Zr-4Mo-2Cr-1Fe β-metastable titanium alloy (β-Cez alloy)

JOURNAL OF ALLOYS AND COMPOUNDS

卷:860

Article

Sharma, Bhupendra^1,2  Denand, Benoit¹  Harcuba, Petr^1,3  Geandier, Guillaume¹  Ameyama, Kei²  Dirras, Guy⁴  Aeby-Gautier, Elisabeth¹ 

[1] Univ Lorraine, CNRS, UMR 7198, Inst Jean Lamour, 2 Allee Andre Guinier BP 50840,Campus ARTME, F-54011 Nancy, France

[2] Ritsumeikan Univ, Fac Sci & Engn, Dept Mech Engn, Kusatsu 5258577, Japan

[3] Charles Univ Prague, Dept Phys Mat, Ke Karlovu 5, Prague 12116, Czech Republic

[4] Univ Paris 13, Sorbonne Paris Cite, 99 Ave Jean Baptiste Clement, F-93430 Villetaneuse, France

关键词: beta-metastable titanium alloys;    Harmonic structures;    Powder metallurgy;    In-situ synchrotron X-ray diffraction;    Phase transformations;   

DOI  :  10.1016/j.jallcom.2020.158483

来源: Elsevier

【 摘 要 】

The present study focuses on the formation of harmonic microstructures in a metastable beta titanium alloy, the p-Cez alloy (Ti-5Al-2Sn-4Zr-4Mo-2Cr-1Fe -T-beta = 895 degrees C). Previous studies emphasized mainly fabrication and improvements in the mechanical properties of alloys prepared by powder metallurgy and showing a harmonic structure. In this study, the harmonic structure was obtained after mechanical milling of the initial powder, followed by a Spark Plasma Sintering (SPS) process. During the process, phase transformations occur that are dependent on the initial state of the powder. Moreover, their kinetics depend on the thermo-mechanical history of the powder. In order to analyze the microstructure formation, the behavior of milled and non-milled powders was studied during a heat treatment similar to the one applied during the SPS process. In-situ high-energy X-ray diffraction was used to characterize the evolution of phases during the thermal treatment. Additional in situ electrical resistivity measurements were carried out on sintered compact specimens. Characterizations evidenced that the initial powder is in a beta metastable state. After mechanical milling, stress/strain induced alpha '' martensite was observed inside the powder's beta grains. The stepwise microstructural characterization revealed the influence of the initial state of the mechanically milled powder on the formation of a harmonic alpha arrangement in the beta matrix consisting of nodular alpha grains in the powder shell and alpha lamellae in the powder core. The stress/strain induced martensite formed during the milling associated with the heavier deformation at the powder surface areas contributes highly to the formation of an arrangement of nodular alpha grains by a recovery/recrystallization phenomenon of beta and alpha ''/alpha phases during the heating. (C) 2020 Elsevier B.V. All rights reserved.

【 授权许可】

Free