Effect of carbon on cryogenic tensile behavior of CoCrFeMnNi-type high entropy alloys

JOURNAL OF ALLOYS AND COMPOUNDS

卷:811

Article

Klimova, M., V¹  Semenyuk, A. O.¹  Shaysultanov, D. G.¹  Salishchev, G. A.¹  Zherebtsov, S., V¹  Stepanov, N. D.¹ 

[1] Belgorod State Univ, Lab Bulk Nanostruct Mat, Pobeda 85, Belgorod 308015, Russia

关键词: High entropy alloys;    Interstitial alloys;    Microstructure;    Mechanical properties;    Transmission electron microscopy;   

DOI  :  10.1016/j.jallcom.2019.152000

来源: Elsevier

【 摘 要 】

High entropy alloys (HEAs) with a face-centered cubic (fcc) structure are considered as promising structural materials, in particular due to their impressive ductility and toughness at cryogenic temperature; at the same time strength of these HEAs is often quite low. An addition of interstitial elements like carbon substantially increases the strength of the fcc HEAs at room temperature, however the effect of C on cryogenic properties has not been properly studied. Therefore in this work we examined cryogenic tensile behavior of the fcc high entropy alloys with different carbon content (0-2 at.%). The alloys had non-equiatomic proportions of principal elements, i.e. Co1Cr0.25Fe1Mn1Ni1. The lower Cr concentration in comparison with the equiatomic alloy led to the higher solubility of carbon confirmed by both ThermoCalc calculations and experimental results; only in the alloy with 2 at.% C a small (<1%) fraction of Crrich M7C3 carbides was found in the as-cast condition. The microstructure of the alloys was not significantly affected by the carbon content and generally consisted of coarse (250-300 mu m) fcc phase grains with dendritic segregations. In turn, the carbon content influenced on mechanical behavior substantially: the strength of the alloys progressively increased with the carbon content along with some reduction in ductility. Solid solution strengthening by carbon at 77 K was much stronger than that at room temperature: 67 MPa/at% and 178 MPa/at%, respectively. The increase in solid solution strengthening agreed well with an anticipated increase in lattice friction at lower temperatures. Plastic deformation was associated with dislocations slip both at 293 K and 77 K; a decrease in temperature and an increase in the carbon concentration increased the inclination to planar slip. The obtained results offer new approaches to increase the cryogenic properties of fcc HEAs. (C) 2019 Elsevier B.V. All rights reserved.

【 授权许可】

Free