Microband-induced plasticity in a Ti-rich high-entropy alloy

JOURNAL OF ALLOYS AND COMPOUNDS

卷:842

Article

Zherebtsov, S.¹  Yurchenko, N.¹  Panina, E.¹  Tojibaev, A.¹  Tikhonovsky, M.²  Salishchev, G.¹  Stepanov, N.¹ 

[1] Belgorod Natl Res Univ, Lab Bulk Nanostruct Mat, Pobeda 85, Belgorod 308015, Russia

[2] NAS Ukraine, Kharkov Inst Phys & Technol, Natl Sci Ctr, UA-61108 Kharkov, Ukraine

关键词: High-entropy alloys;    Deformation;    Microstructure evolution;    Planar slip;    Microbands;   

DOI  :  10.1016/j.jallcom.2020.155868

来源: Elsevier

【 摘 要 】

Microstructure evolution and mechanical behavior of an Al4Mo4Nb8Ti50Zr34 high-entropy alloy were studied. In the as-cast condition, the alloy had a single-phase weakly B2 ordered bcc structure with a grain size of 100 +/- 50 mu m. The microstructure evolution during cold rolling to 90% thickness strain was initially associated with the development of substructure in the form of slip bands and then the formation of deformation bands propagating through several grains. Annealing of the cold-rolled alloy at T >= 700 degrees C resulted in the formation of a recrystallized microstructure with grain sizes varying from similar to 6 mu m after annealing at 600 degrees C to similar to 250 mu m at 1000 degrees C. A small fraction of tiny oxides was observed in the alloy annealed at 700 degrees C; the particles did not influence noticeably on the alloy properties. In spite of lack of work hardening in both the as-cast and recrystallized conditions, the alloy demonstrated the yield strength of 825-910 MPa and elongation to fracture of 11.5-15.2%. This behavior can be associated with strain localization due to the formation of dislocation microbands in the weakly B2 ordered bcc matrix. (C) 2020 Elsevier B.V. All rights reserved.

【 授权许可】

Free