Life cycle assessment of resource recovery from municipal solid waste incineration bottom ash

JOURNAL OF ENVIRONMENTAL MANAGEMENT

卷:151

Article

Allegrini, Elisa¹  Vadenbo, Carl²  Boldrin, Alessio¹  Astrup, Thomas Fruergaard¹ 

[1] Tech Univ Denmark, Dept Environm Engn, DK-2800 Lyngby, Denmark

[2] ETH, Inst Environm Engn, CH-8093 Zurich, Switzerland

关键词: MSWI;    Bottom ash;    Scrap metal recovery;    Aluminum recycling;    LCA;    Metals leaching;   

DOI  :  10.1016/j.jenvman.2014.11.032

来源: Elsevier

【 摘 要 】

Bottom ash, the main solid output from municipal solid waste incineration (MSWI), has significant potential for the recovery of resources such as scrap metals and aggregates. The utilisation of these resources ideally enables natural resources to be saved. However, the quality of the recovered scrap metals may limit recycling potential, and the utilisation of aggregates may cause the release of toxic substances into the natural environment through leaching. A life cycle assessment (LCA) was applied to a full-scale MSWI bottom ash management and recovery system to identify environmental breakeven points beyond which the burdens of the recovery processes outweigh the environmental benefits from valorising metals and mineral aggregates. Experimental data for the quantity and quality of individual material fractions were used as a basis for LCA modelling. For the aggregates, three disposal routes were compared: landfilling, road sub-base and aggregate in concrete, while specific leaching data were used as the basis for evaluating toxic impacts. The recovery and recycling of aluminium, ferrous, stainless steel and copper scrap were considered, and the importance of aluminium scrap quality, choice of marginal energy technologies and substitution rates between primary and secondary aluminium, stainless steel and ferrous products, were assessed and discussed. The modelling resulted in burdens to toxic impacts associated with metal recycling and leaching from aggregates during utilisation, while large savings were obtained in terms of non-toxic impacts. However, by varying the substitution rate for aluminium recycling between 0.35 and 0.05 (on the basis of aluminium scrap and secondary aluminium alloy market value), it was found that the current recovery system might reach a breakeven point between the benefits of recycling and energy expended on sorting and upgrading the scrap. (C) 2014 Elsevier Ltd. All rights reserved.

【 授权许可】

Free