Photocatalytic degradation of industrial pulp and paper mill effluent using synthesized magnetic Fe2O3-TiO2: Treatment efficiency and characterizations of reused photocatalyst

JOURNAL OF ENVIRONMENTAL MANAGEMENT

卷:187

Article

Subramonian, Wennie¹  Wu, Ta Yeong¹  Chai, Siang-Piao¹ 

[1] Monash Univ, Sch Engn, Chem Engn Discipline, Jalan Lagoon Selatan, Bandar Sunway 47500, Selangor Darul, Malaysia

关键词: Coagulation-flocculation;    Green synthesis;    Mechanochemical milling;    Photocatalysis;    Response surface methodology;    Wastewater treatment;   

DOI  :  10.1016/j.jenvman.2016.10.024

来源: Elsevier

【 摘 要 】

In this work, heterogeneous photocatalysis was used to treat pulp and paper mill effluent (PPME). Magnetically retrievable Fe2O3-TiO2 was fabricated by employing a solvent-free mechanochemical process under ambient conditions. Findings elucidated the successful incorporation of Fe2O3 into the TiO2 lattice. Fe2O3-TiO2 was found to be an irregular and slightly agglomerated surface morphology. In comparison to commercial P25, Fe2O3-TiO2 exhibited higher ferromagnetism and better catalyst properties with improvements in surface area (58.40 m(2)/g), pore volume (0.29 cm(3)/g), pore size (18.52 nm), and band gap (2.95 eV). Besides, reusability study revealed that Fe2O3-TiO2 was chemically stable and could be reused successively (five cycles) without significant changes in its photoactivity and intrinsic properties. Additionally, this study demonstrated the potential recovery of Fe2O3-TiO2 from an aqueous suspension by using an applied magnetic field or sedimentation. Interactive effects of photocatalytic conditions (initial effluent pH, Fe2O3-TiO2 dosage, and air flow-rate), reaction mechanism, and the presence of chemical oxidants (H2O2, BrO3-, and HOCl) during the treatment process of PPME were also investigated. Under optimal conditions (initial effluent pH = 3.88, [Fe2O3-TiO2] = 13 g/L, and air flow rate = 2.28 L/min), the treatment efficiency of Fe2O3-TiO2 was 98.5% higher than the P25. Based on Langmuir-Hinshelwood kinetic model, apparent rate constants of Fe2O3-TiO2 and P25 were 9.2 x 10(-3) and 2.7 x 10(-3) min(-1), respectively. The present study revealed not only the potential of using magnetic Fe2O3-TiO2 in PPME treatment but also demonstrated high reusability and easy separation of Fe2O3-TiO2 from the wastewater. (C) 2016 Elsevier B.V. All rights reserved.

【 授权许可】

Free