The influence of low-energy helium plasma on bubble formation in micro-engineered tungsten

JOURNAL OF NUCLEAR MATERIALS

卷:501

Article

Gao, Edward¹  Nadvornick, Warren¹  Doerner, Russ²  Ghoniem, Nasr M.¹ 

[1] Univ Calif Los Angeles, Dept Mech & Aerosp Engn, 420 Westwood Plaza, Los Angeles, CA 90095 USA

[2] Univ Calif San Diego, Ctr Energy Res, 9500 Gilman Dr, La Jolla, CA 92093 USA

关键词: Helium bubbles;    Tungsten;    Micro-engineered materials;    Plasma-material interaction;    Tungsten fuzz;   

DOI  :  10.1016/j.jnucmat.2018.01.040

来源: Elsevier

【 摘 要 】

Four different types of micro-engineered tungsten surfaces were exposed to low energy helium plasma, with a planar surface as control. These samples include two surfaces covered with uniform W-coated rhenium micro-pillars; one with cylindrical pillars 1 mu m in diameter and 25 mu m in height, and one with dendritic conical pillars 4-10 mu m in diameter and 20 mu m in height. Additionally, two samples with reticulated open-cell foam geometry, one at 45 pores per inch (PPI), and the other at 80 PPI were fabricated with Chemical Vapor Deposition (CVD). The samples were exposed to helium plasma at 30-100 eV ion energy, 823-1123 K temperature, and 5 x 10(25) -2 x 10(26) m(-2) ion fluence. It is shown that the formation of nanometer-scale tendrils (fuzz) on micro-engineered W surfaces is greatly reduced as compared to planar surfaces. This is attributed to more significant ion backscattering and the increased effective surface area that intercept incident ions in micro-engineered W. A 20% decrease in the average ion incident angle on pillar type surfaces leads to similar to 30% decrease in bubble size, down to 30 nm in diameter. W fuzz was found to be absent from pillar sides due to high ion backscattering rates from pillar sides. In foam samples, 28% higher PPI is observed to have 24.7%-36.7% taller fuzz, and 17.0%-25.0% larger subsurface bubbles. These are found to be an order of magnitude smaller than those found in planar surfaces of similar environment. The helium bubble density was found to increase with ion energy in pillars, roughly from 8.2% to 48.4%, and to increase with increasing PPI, from 36.4% to 116.2%, and with bubble concentrations up to 9.1 x 10(21) m(-3). Geometric shadowing effects in or near surface ligaments are observed in all foam samples, with near absence of helium bubbles or fuzz in deeper layers of the foam. (C) 2018 Elsevier B.V. All rights reserved.

【 授权许可】

Free