Identification of the ferromagnetic hysteresis simulation parameters using classic non-destructive testing equipment

JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS

卷:531

Article

Zhang, S.¹  Ducharne, B.^2,3  Takeda, S.¹  Sebald, G.²  Uchimoto, T.^1,2 

[1] Tohoku Univ, Inst Fluid Sci IFS, Sendai, Miyagi, Japan

[2] Univ Lyon, Tohoku Univ, CNRS, Int Joint Unit,ELyTMaX UMI 3757, Sendai, Miyagi, Japan

[3] INSA Lyon, LGEF, Villeurbanne, France

关键词: Ferromagnetic hysteresis simulation;    Magnetic incremental permeability;    Eddy current testing;    Dodd and Deeds model;    Jiles-Atherton model;   

DOI  :  10.1016/j.jmmm.2021.167971

来源: Elsevier

【 摘 要 】

Electromagnetic non-destructive controls are performed daily by steel manufacturers and steel user companies. Many methods exist, including Eddy Current Testing (ECT), Magnetic Particle Inspection (MPI), Magnetic Incremental Permeability (MIP), Magnetic Barkhausen noise (MBN) ... In this domain, progresses are constant, however there are limitations and accurate simulation tools able to improve the methods efficiency are still expected. Most of steels are ferromagnetic and characterized by a strong nonlinear hysteretic magnetic behavior. A precise taken into account of hysteresis is mandatory in the development of useful simulation tools. The hysteresis standard of characterization imposes restrictive conditions (geometrical, electrical ...) and most of Non-Destructive Testing (NDT) industrial end-users face difficulties to obtain these inevitable experimental results. In this manuscript, we describe an alternative method to adjust the hysteresis simulation parameters based on experimental results coming from classic NDT industrial equipment. The acquisition of a flat coil impedance in an ECT configuration and under the superimposition of a quasi-static magnetic excitation (MPI equipment) is performed to plot the tested specimen MIP signature. The Dodd & Deeds (D&D) analytical solution for an ECT flat coil is used to return the corresponding permeability. An optimization process based on a modified JilesAtherton (J-A) model is run to extract a suitable combination of hysteresis parameters. Finally, the good comparison with an experimental B(H) characterization is worth as a validation of the method.

【 授权许可】

Free