Effects of sintering temperature on grain growth and the complex permeability of Co0.2NiO0.3Zn0.5Fe2O4 material prepared using mechanically alloyed nanoparticles

JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS

卷:323

Article

Waje, Samaila Bawa¹  Hashim, Mansor^2,3  Ismail, Ismayadi³ 

[1] King Fahd Univ Petr & Minerals, Harf Al Baten 31991, Saudi Arabia

[2] Univ Putra Malaysia, Inst Adv Technol, Adv Mat & Nanotechnol Lab, Upm Serdang 43400, Selangor, Malaysia

[3] Univ Putra Malaysia, Fac Sci, Dept Phys, Upm Serdang 43400, Selangor, Malaysia

关键词: Mechanical alloying;    Sintering temperature;    Nanoparticles;    Permeability;   

DOI  :  10.1016/j.jmmm.2010.12.032

来源: Elsevier

【 摘 要 】

Nanoparticle-sized Co0.2Ni0.3Zn0.5Fe2O4 was prepared using mechanical alloying and sintering. The starting raw materials were milled in air and subsequently sintered at various temperatures from 600 to 1300 degrees C. The effects of sintering temperature on physical, magnetic and electrical characteristics were studied. The complex permittivity and permeability were investigated in the frequency range 10 MHz to 1.0 GHz. The results show that single phase Co0.2Ni0.3Zn0.5Fe2O4 could not be formed during milling alone and therefore requires sintering. The crystallization of the ferrite sample increases with increasing sintering temperature; which decrease the porosity and increase the density, crystallite size and the shrinkage of the material. The maximum magnetization value of 83.1 emu/g was obtained for a sample sintered at 1200 degrees C, while both the retentivity and the coercivity decrease with increasing the sintering temperature. The permeability values vary with both the sintering temperature and the frequency and the absolute value of the permeability decreased after the natural resonance frequency. The real part of the permittivity was constant within the measured frequency, while the loss tangent values decreased gradually with increasing frequency. (C) 2010 Elsevier B.V. All rights reserved.

【 授权许可】

Free