Utilization of municipal wastewater for cooling in thermoelectric power plants

FUEL

卷:111

Article

Safari, Iman¹  Walker, Michael E.¹  Hsieh, Ming-Kai²  Dzombak, David A.²  Liu, Wenshi³  Vidic, Radisav D.³  Miller, David C.⁴  Abbasian, Javad¹ 

[1] IIT, Chicago, IL 60616 USA

[2] Carnegie Mellon Univ, Pittsburgh, PA 15213 USA

[3] Univ Pittsburgh, Pittsburgh, PA USA

[4] Natl Energy Technol Lab, Morgantown, WV USA

关键词: Municipal wastewater;    Cooling system;    Thermoelectric power plant;    Water Chemistry and Quality;    Modeling and Simulation;   

DOI  :  10.1016/j.fuel.2013.03.062

来源: Elsevier

【 摘 要 】

A process simulation model has been developed using Aspen Plus (R) with the OLI (OLI System, Inc.) water chemistry model to predict water quality in the recirculating cooling loop utilizing secondary-and tertiary-treated municipal wastewater as the source of makeup water. Simulation results were compared with pilot-scale experimental data on makeup water alkalinity, loop pH, and ammonia evaporation. The effects of various parameters including makeup water quality, salt formation, NH3 and CO2 evaporation mass transfer coefficients, heat load, and operating temperatures were investigated. The results indicate that, although the simulation model can capture the general trends in the loop pH, experimental data on the rates of salt precipitation in the system are needed for more accurate prediction of the loop pH. It was also found that stripping of ammonia and carbon dioxide in the cooling tower can influence the cooling loop pH significantly. The effects of the NH3 mass transfer coefficient on cooling loop pH appear to be more significant at lower values (e. g., k(NH3) < 4 x 10 (3) m/s) when the makeup water alkalinity is low (e. g., <90 mg/L as CaCO3). The effect of the CO2 mass transfer coefficient was found to be significant only at lower alkalinity values (e. g., k(CO2) < 4 x 10 (6) m/s). (C) 2013 Elsevier Ltd. All rights reserved.

【 授权许可】

Free