Experimental evaluation of direct current magnetron sputtered and high-power impulse magnetron sputtered Cr coatings on SiC for light water reactor applications

THIN SOLID FILMS

卷:716

Article

Quillin, Kyle¹  Yeom, Hwasung²  Dabney, Tyler¹  McFarland, Mike³  Sridharan, Kumar^1,2 

[1] Univ Wisconsin, Dept Mat Sci & Engn, Madison, WI 53706 USA

[2] Univ Wisconsin, Dept Engn Phys, Madison, WI 53706 USA

[3] Acree Technol Inc, Concord, CA 94520 USA

关键词: Silicon carbide cladding;    fuel cladding;    hydrothermal corrosion;    chromium coating;    physical vapor deposition;    high-power impulse magnetron sputtering;    accident tolerant fuel;   

DOI  :  10.1016/j.tsf.2020.138431

来源: Elsevier

【 摘 要 】

Two types of physical vapor deposition Cr coatings were deposited on chemical vapor deposited SiC coupons using conventional direct current magnetron sputtering (DCMS) and high-power impulse magnetron sputtering (HiPIMS) to mitigate the corrosion of SiC, an advanced fuel and structural material in light water nuclear reactor cores. Coating microstructure was characterized using scanning electron microscopy and scanning transmission election microscopy. X-ray diffraction analysis was conducted for phase identification and qualitative analysis of residual stresses. The mechanical integrity of the coatings was evaluated using scratch testing, micro-indentation, and nano-indentation tests. The microstructure of the DCMS coating consisted of fine columnar grains with nanoscale intercolumnar channels, while the HiPIMS microstructure was denser and free of any columnar defects. The DCMS coating showed a small tensile residual stress, while the HiPIMS coating was under compressive stress. Both types of coatings showed good mechanical integrity in terms of ductility and adhesion to the substrate. Corrosion performance of the coatings was assessed with a 30-day high temperature water autoclave test. Both types of coatings formed a protective Cr2O3 surface layer 20-30 nm thick during the autoclave test. In the DCMS coating, the columnar defects provided permeation pathways for water penetration resulting in oxide formation in the intercolumnar regions in the interior of the coating. Overall, both types of Cr coatings offer promise for the mitigation of hydrothermal corrosion of SiC in light water reactor operating environments.

【 授权许可】

Free