Use of constrained focused waves to measure extreme loading of a taut moored floating wave energy converter

OCEAN ENGINEERING

卷:148

Article

Hann, Martyn¹  Greaves, Deborah¹  Raby, Alison¹  Howey, Ben¹ 

[1] Plymouth Univ, Sch Engn, Plymouth, Devon, England

关键词: NewWave;    Constrained NewWave;    Wave impact;    Survivability;    Moorings;    Floating bodies;   

DOI  :  10.1016/j.oceaneng.2017.10.024

来源: Elsevier

【 摘 要 】

This paper concerns experimental measurements of the interaction of a taut moored floating body, representing a point absorbing wave energy converter in survivability mode, with extreme waves. The extreme waves are modelled in four ways. NewWave theory is first used to generate focused wave groups of varying steepness. Steepness is shown to have negligible effect on peak mooring loads, but causes significant differences in the resulting motion. The NewWave group is then constrained into both regular and irregular background wave trains so that the floating body has a load history caused by previous waves when interacting with the focused wave group. It is shown that an independent focused wave group is insufficient to properly model the extreme response of the floating body. However differences between the target and measured constrained time series due to non-linear wave-wave interaction limited the potential benefits of this approach. Finally the results from these tests are compared with measurements taken using irregular waves without any deterministic focused wave groups present. This comparison found cases where the floats response was greater than during any of the constrained NewWave tests, indicating that the assumption made that NewWave will generate the largest response was incorrect in this case.

【 授权许可】

Free