Iridium and Ruthenium oxide miniature pH sensors: Long-term performance

SENSORS AND ACTUATORS B-CHEMICAL

卷:297

Article

Mingels, R. H. G.¹  Kalsi, S.¹  Cheong, Y.²  Morgan, H.¹ 

[1] Univ Southampton, Elect & Comp Sci, Southampton SO17 1BJ, Hants, England

[2] Univ Southampton, Sch Med, Southampton SO17 1BJ, Hants, England

关键词: Ruthenium oxide;    Iridium oxide;    pH Sensor;    Impedance;    Long term sensing;    Metal oxide pH sensor;   

DOI  :  10.1016/j.snb.2019.126779

来源: Elsevier

【 摘 要 】

The characteristics of electrodeposited Iridium oxide films (EIROF), and Ruthenium oxide films (RUOF) under normal and annealed conditions have been investigated. RUOFs were sputter deposited onto a substrate whilst EIROF sensors were made by electrodeposition. The adhesion of the RUOF sensors was investigated on Platinum and Titanium surfaces. The electrical impedance of the two metal oxides was measured in PBS demonstrating that both films have up to a 100 fold higher electrical double layer capacitance than bright Platinum electrodes. The EIROF films show super-Nernstian response, but the formal potential shows a continuous drift with time of approximately 2 mV day(-1), measured over 40 days. Both RUOF sensors show approximately Nernstian behaviour. Short term pH precision of the annealed RUOF falls within a confidence interval of +/- 0.1 pH, and stability is maintained within a confidence of +/- 0.24 pH for up to 147 days. The un-annealed RUOF maintains the same precision but only for 20 days. Compared to EIROF sensors, no drift correction is required for the annealed RUOF making this metal oxide suitable for long term measurements where re-calibration is not possible.

【 授权许可】

Free