Neutron diffraction measurements of residual stress in additively manufactured stainless steel

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:678

Article

Brown, D. W.¹  Bernardin, J. D.¹  Carpenter, J. S.¹  Clausen, B.¹  Spernjak, D.¹  Thompson, J. M.¹ 

[1] Los Alamos Natl Lab, Los Alamos, NM 87545 USA

关键词: Additive manufacture;    Neutron diffraction;    Residual stress;   

DOI  :  10.1016/j.msea.2016.09.086

来源: Elsevier

【 摘 要 】

Charpy test specimens were additively manufactured (AM) on a single stainless steel plate from a 17-4 class stainless steel using a powder-bed, laser melting technique on an EOS M280 direct metal laser sintering (DMLS) machine. Cross-hatched mesh support structures for the Charpy test specimens were varied in strut width and density to parametrically study their influence on the build stability and accuracy as the DMLS process has been known to generate parts with large amounts of residual stress. Neutron diffraction was used to profile the residual stresses in several of the AM samples before and after the samples were removed from the support structure for the purpose of determining residual stresses. The residual stresses were found to depend very little on theproperties of the support structure over the limited range studied here. The largest stress component was in the long direction of each of the samples studied and was roughly 2/3 of the yield stress of the material. The stress field was altered considerably when the specimen was removed from the support structure. It was noted in this study that a single Charpy specimen developed a significant tear between the growth plate and support structure. The presence of the tear in the support structure strongly affected the observed stress field: the asymmetric tear resulted in a significantly asymmetric stress field that propagated through removal of the sample from the base plate. The altered final residual stress state of the sample as well as its observed final shape indicates that the tear initiated during the build and developed without disrupting the fabrication process, suggesting a need for in-situ monitoring.

【 授权许可】

Free