Mechanical properties of a new high entropy alloy with a duplex ultra-fine grained structure

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:728

Article

Stepanov, N. D.¹  Shaysultanov, D. G.¹  Chernichenko, R. S.¹  Ikornikov, D. M.²  Sanin, V. N.²  Zherebtsov, S. V.¹ 

[1] Belgorod State Univ, Lab Bulk Nanostruct Mat, Pobeda 85, Belgorod 308015, Russia

[2] Russian Acad Sci, Merzhanov Inst Struct Macrokinet & Mat Sci, Moscow 142432, Russia

关键词: High entropy alloys;    UFG structure;    Phase transformations;    Mechanical properties;    Grain boundary strengthening;   

DOI  :  10.1016/j.msea.2018.04.118

来源: Elsevier

【 摘 要 】

A new approach to increase the tensile performance of high entropy alloys (HEAs) by producing a duplex ultrafine-grained (UFG) structure was reported in this work. A novel HEA based on the CoCrFeNiMn system with substantial amounts of Al and C was used for the illustration of this approach. In the as-cast condition the alloy had almost entirely a single face-centered cubic (fcc) phase structure with an insignificant amount of M23C6 carbides. After cold rolling and annealing at 800-1000 degrees C an increased amount of fine second phases, namely M23C6 carbides and B2 phase, effectively pinned boundaries of recrystallized fcc grains. As a result, a duplex UFG structure composed of the recrystallized fcc grains and M23C6 and B2 particles was produced. The alloy with the UFG structure demonstrated attractive mechanical properties. For example, after annealing at 900 degrees C the alloy had the yield strength of 785 MPa, the ultimate tensile strength of 985 MPa, and elongation to fracture of 32%. The phase composition of the alloy in different conditions was compared with the equilibrium phase diagram obtained using a Thermo-Calc software. Strengthening mechanisms were qualitatively analyzed, and some possibilities for further improvement of strength of the alloy were discussed.

【 授权许可】

Free