Fatigue behavior of ASTM A131 EH36 steel samples additively manufactured with selective laser melting

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:777

Article

Wang, Jingjing¹  Zhang, Meng¹  Tan, Xipeng¹  Liu, Tong²  Bi, Guijun²  Li, Hua³  Tor, Shu Beng³  Liu, Erjia³ 

[1] Nanyang Technol Univ, Singapore Ctr 3D Printing, 50 Nanyang Ave, Singapore, Singapore

[2] Singapore Inst Mfg Technol, 73 Nanyang Dr, Singapore, Singapore

[3] Nanyang Technol Univ, Sch Mech & Aerosp Engn, 50 Nanyang Ave, Singapore, Singapore

关键词: A131 EH36 steel;    Selective laser melting;    Fatigue behavior;    Fracture mechanism;    Microstructure;   

DOI  :  10.1016/j.msea.2020.139049

来源: Elsevier

【 摘 要 】

By tuning the process parameters mainly scanning speed ASTM A131 EH36 steel samples with high strength (1000 MPa) and fair ductility (10%) were additively manufactured through a selective laser melting process. A dual phase structure consisting of recrystallized fine ferrite and highly tempered martensite (<30%) resulted from a lower laser scanning speed of 100 mm/s. The higher heat input incurred with lower scanning speed improved the densification of the built samples, which was beneficial for achieving enhanced mechanical properties. Fatigue life cycles of the samples built at lower scanning speeds surpassed those built at higher scanning speeds. Porosity induced failure was found to dominate the high cycle fatigue failure for all the samples printed, which was attributed to the ubiquitous distribution of the pores in large quantity and size with complex shapes. Grain orientation in the horizontally built samples favoured crack propagation in the early stage, which was believed to contribute to the lowered fatigue limit and life. The stable crack propagation and fast fracture regime were characterized by tearing topology surface and dimples, respectively, for the samples. The fatigue behavior of the printed EH36 steel samples was correlated to their microstructure as well as the printing process conditions. Soft phases such as retained austenite and coarsened ferrite, etc. may contribute to the fatigue behavior of the samples in certain aspect.

【 授权许可】

Free