Study of the microstructure resulting from brazed aluminium materials used in heat exchangers

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:413

Article; Proceedings Paper

Lacaze, J ; Tierce, S ; Lafont, MC ; Thebault, Y ; Pébère, N ; Mankowski, G ; Blanc, C ; Robidou, H ; Vaumousse, D ; Daloz, D

关键词: aluminium materials;    heat exchangers;    microstructure;    brazing;    solidification;   

DOI  :  10.1016/j.msea.2005.08.187

来源: Elsevier

【 摘 要 】

Re-solidification of AA4343 cladding after brazing as well as the related precipitation in the modified AA3003 core material have been investigated. Analysis of the re-solidified material showed that partial dissolution of the core alloy occurs in both the brazing joints and away of them. Far from the brazing joints, the dissolution is, however, limited and diffusion of silicon from the liquid into the core material leads to solid-state precipitation in the so-called band of dense precipitates (BDP). On the contrary, the dissolution is enhanced in the brazing joint to such an extent that no BDP could be observed. The intermetallic phases present in the re-solidified areas as well as in the core material have been analyzed and found to be mainly cubic alpha-Al(Mn,Fe)Si. These results were then compared to predictions made with available phase diagram information. (c) 2005 Elsevier B.V. All rights reserved.

【 授权许可】

Free