Local identification of the stress-strain curves of metals at a high strain rate using repeated micro-impact testing

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:569

Article

Kermouche, G.¹  Grange, F.²  Langlade, C.³ 

[1] Ecole Natl Super Mines, SMS Dept, LGF Lab UMR CNRS 5307, F-42023 St Etienne 2, France

[2] Univ Lyon, Ecole Natl Ingn St Etienne, Lab Tribol & Dynam Syst, UMR CNRS ECL ENISE 5513, F-42023 St Etienne 2, France

[3] Univ Technol Belfort Mt Beliard, LERMPS Lab, EA 3316, F-90010 Belfort, France

关键词: Multi-impact;    Indentation;    Metal materials;    High strain rate;    Stress-strain curve;    Inverse method;   

DOI  :  10.1016/j.msea.2013.01.020

来源: Elsevier

【 摘 要 】

Understanding the effect of various mechanical processes such as shot peening requires the knowledge of metal behavior at a high strain rate. The identification of this behavior is often performed using Hopkinson's bar devices. However, the resulting stress strain curves correspond to a bulk behavior of the material and thus do not take into account the modification induced by surface preparations or surface treatments. In this paper, we have proposed a method based on local micro-impact testing to identify the stress strain curves of metals near their surface. More precisely, this method is based on the determination of the best stress strain curve which allows to reproduce the growth of the residual imprint at each impact for a given impact energy. The advantage of the method developed in this paper lies in its simplicity and low cost. In the first part, the repeated impact set-up is presented. Then the FEM strategy is detailed and the identification method developed. In the last part of this paper, an application to AISI1045 and AISI316L steels highlights the great interest of this method to obtain better stress strain curves than those classically used. It points out the need to identify appropriate surface stress strain curves when the surface behavior is concerned. As a matter of fact it should also concern other manufacturing processes such as machining or finishing. (C) 2013 Elsevier B.V. All rights reserved.

【 授权许可】

Free