Predicting failure modes in creep and creep-fatigue crack growth using a random grain/grain boundary idealised microstructure meshing system

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:704

Article

Zhao, Lei¹  Xu, Lianyong¹  Nikbin, Kamran² 

[1] Tianjin Univ, Sch Mat Sci & Engn, Tianjin 300072, Peoples R China

[2] Imperial Coll London, Dept Mech Engn, London SW7 2AZ, England

关键词: Creep-fatigue regime;    Damage model;    Microstructural modelling;    Crack growth;   

DOI  :  10.1016/j.msea.2017.08.035

来源: Elsevier

【 摘 要 】

An idealised microstructure mesh model combined with a novel creep and creep-fatigue damage accumulation model was employed to simulate crack growth behaviour under creep/fatigue conditions for a modified 9Cr-1Mo steel. The influence of microstructures on the crack growth behaviour was studied using a random grains separated by idealised grain boundaries. For accurately representing the damage accumulation in creep-fatigue regime, a non-linear damage model was employed. In this case, creep damage was determined by multiaxial ductility exhaustion approach and fatigue damage was reliant on maximum stress and plastic range ahead of crack tip per loading cycle. When creep dominated, cracks mainly propagated along grain boundaries in steady crack growth stage. As an exception, the crack growth in the tertiary crack growth stage gradually changed from intergranular to mixed model and finally transgranular fracture. In contrast, in creep-fatigue regime, the crack growth behaviour was greatly reliant on the dwell time. For short duration period, the crack mainly propagated in a transgranular manner. But as the dwell time increased to greater than 600 s, the creep intergranular fracture dominated once again. Furthermore, the grain size gradient had little influence on the crack growth model and only affected the fracture life in creep and creep-fatigue regimes.

【 授权许可】

Free