Influence of high-pressure gaseous hydrogen on the low-cycle fatigue and fatigue crack growth properties of a cast titanium alloy

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:612

Article

Gaddam, R.¹  Hornqvist, M.²  Antti, M. -L.¹  Pederson, R.¹ 

[1] Lulea Univ Technol, Div Mat Sci, S-97187 Lulea, Sweden

[2] Chalmers, Dept Appl Phys, S-41296 Gothenburg, Sweden

关键词: Titanium alloys;    Fatigue;    Fracture;    Hydrogen embrittlement;    Mechanical characterisation;    Electron microscopy;   

DOI  :  10.1016/j.msea.2014.06.060

来源: Elsevier

【 摘 要 】

In the present study, the effect of gaseous hydrogen on the fatigue properties of a commonly used aerospace titanium alloy (Ti-6Al-4V) was studied. The low-cycle fatigue and fatigue crack growth properties were investigated at room temperature in ambient air and 15 MPa gaseous hydrogen. Results showed that the low-cycle fatigue life was significantly reduced in hydrogen, and the detrimental effect was larger at higher strain amplitudes. The fatigue crack growth rate in hydrogen remained unaffected below a critical stress intensity Delta K* approximate to 17 MPa root m, while beyond this value, the fatigue crack growth rate fluctuated and increased with increasing Delta K. Fractography analysis clearly showed that gaseous hydrogen mainly affected the fatigue crack growth rate. On the fracture surfaces, striations were noted over the entire crack growth region in air, whereas in hydrogen striations were noted at stress intensities lower than Delta K*. Above Delta K*, secondary cracks and brittle flat surfaces with features similar to crack arrest marks were mostly observed in hydrogen. Microstructural analysis along the crack growth direction showed that the crack followed a transgranular path in air, i.e. through alpha colonies. In hydrogen, the crack also grew along the prior beta grain boundaries and at alpha/beta interface within the alpha colonies. Thereby, the detrimental effect of hydrogen in cast titanium alloy was attributed to a change in the fracture process during crack propagation. (C) 2014 Elsevier B.V. All rights reserved.

【 授权许可】

Free