Laminated Ti-Al composites: Processing, structure and strength

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:673

Article

Du, Yan^1,2  Fan, Guohua¹  Yu, Tianbo²  Hansen, Niels²  Geng, Lin¹  Huang, Xiaoxu² 

[1] Harbin Inst Technol, Sch Mat Sci & Engn, Harbin 150001, Peoples R China

[2] Tech Univ Denmark, Dept Wind Energy, Sect Mat Sci & Adv Characterizat, Riso Campus, DK-4000 Roskilde, Denmark

关键词: Electron microscopy;    Mechanical characterization;    Composites;    Thermomechanical processing;    Interfaces;   

DOI  :  10.1016/j.msea.2016.07.108

来源: Elsevier

【 摘 要 】

Laminated Ti-Al composite sheets with different layer thickness ratios have been fabricated through hot pressing followed by multi-pass hot rolling at 500 degrees C. The laminated sheets show strong bonding with intermetallic interface layers of nanoscale thickness between the layers of Ti and Al. The mechanical properties of the composites with different volume fractions of Al from 10% to 67% show a good combination of strength and ductility. A constraint strain in the hot-rolled laminated structure between the hard and soft phases introduces an elastic-plastic deformation stage, which becomes more pronounced as the volume fraction of Al decreases. Moreover, the thin intermetallic interface layer may also contribute to the strength of the composites, and this effect increases with increasing volume fraction of the interface layer. (C) 2016 Elsevier B.V. All rights reserved.

【 授权许可】

Free