Effect of laser shock peening on residual stress and fatigue life of clad 2024 aluminium sheet containing scribe defects

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:548

Article

Dorman, M.²  Toparli, M. B.³  Smyth, N.¹  Cini, A.¹  Fitzpatrick, M. E.³  Irving, P. E.¹ 

[1] Cranfield Univ, Dept Mat, Cranfield MK43 0AL, Beds, England

[2] Cranfield Univ, Dept Aerosp Engn, Cranfield MK43 0AL, Beds, England

[3] Open Univ, Milton Keynes MK7 6AA, Bucks, England

关键词: Laser peening;    Aluminium sheet;    Fatigue;    Residual stresses;    Crack growth;   

DOI  :  10.1016/j.msea.2012.04.002

来源: Elsevier

【 摘 要 】

Laser peening at a range of power densities has been applied to 2 mm-thick sheets of 2024 T351 aluminium. The induced residual stress field was measured using incremental hole drilling and synchrotron X-ray diffraction techniques. Fatigue samples were subjected to identical laser peening treatments followed by scribing at the peen location to introduce stress concentrations, after which they were fatigue tested. The residual stresses were found to be non-biaxial: orthogonal to the peen line they were tensile at the surface, moving into the desired compression with increased depth. Regions of peen spot overlap were associated with large compression strains; the centre of the peen spot remaining tensile. Fatigue lives showed moderate improvement over the life of unpeened samples for 50 mu m deep scribes, and slight improvement for samples with 150 mu m scribes. Use of the residual stress intensity K-resid approach to calculate fatigue life improvement arising from peening was unsuccessful at predicting the relative effects of the different peening treatments. Possible reasons for this are explored. (C) 2012 Elsevier B.V. All rights reserved.

【 授权许可】

Free