The effect of high hydraulic loading rate on the removal efficiency of a quadruple media filter for tertiary wastewater treatment

WATER RESEARCH

卷:107

Article

Ncube, Philani¹  Pidou, Marc¹  Stephenson, Tom¹  Jefferson, Bruce¹  Jarvis, Peter¹ 

[1] Cranfield Univ, Cranfield Water Sci Inst, Coll Rd, Cranfield MK43 0TE, Beds, England

关键词: Filtration;    Wastewater;    Hydrodynamics;    Particles;    Media;   

DOI  :  10.1016/j.watres.2016.10.060

来源: Elsevier

【 摘 要 】

It is well known that filtration removal efficiency falls with an increase in flow rate; however, there is limited supporting experimental data on how removal efficiency changes for filters with multiple layers of media and for wastewater filtration, a practice that is becoming more common. Furthermore, information is not available on the characteristics of particles that are removed at different flow rates. Here, a quadruple media filter was operated at hydraulic loading rates (HLRs) between 5 and 60 mh(-1) with subsequent measurement of total suspended solids, turbidity and particle size distribution (PSD). Samples were collected from the filter influent, effluent and also from between media layers. Pressure changes across the filter layers were also measured. The solids removal efficiency of the filter varied inversely with the increase in filtration rate. However, the multiple media layers reduced the negative impact of increased HLR in comparison to a single media filter. High filtration rates were shown to transport solids, such that particle retention and headloss development was distributed across the entire depth of the multi-media filter. There was also a progressive decrease in the suspension particle size leaving each of the filter layers. The particle hydrodynamic force simulation was consistent with the changes in measured PSD through the filter layers. (C) 2016 Elsevier Ltd. All rights reserved.

【 授权许可】

Free