A Highly Linear Receiver Using Parallel Preselect Filter for 5G Microcell Base Station Applications

卷:58

Article

关键词: NOISE-CANCELING RECEIVER;    WIDE-BAND RECEIVER;    MIXER-1ST RECEIVER;    BLOCKER-TOLERANT;    RF;    DESIGN;    SUPPRESSION;    SELECTIVITY;    LO;   

DOI  :  10.1109/JSSC.2023.3267723

来源: SCIE

【 摘 要 】

By introducing three different techniques, this article, for the first time, presents a wideband highly linear receiver (RX) capable of handling blocking scenarios in fifth-generation (5G) microcell base station applications. First, a parallel preselect filter is introduced to satisfy the base station co-location blocking requirements. Next, a combination of third-order RF and base band (BB) filters is adopted to attenuate close-in blockers by a -120 dB/dec roll-off. Finally, a translational feedback network is proposed to reduce the in-band gain ripple to below 0.5 dB and provide better than -19 dB input matching. Fabricated in the 40-nm CMOS technology, the proposed RX occupies a core area of 0.8 mm2 and consumes 108-176 mW from a 1.3 V supply over the RX's 0.5-3-GHz operating frequency. It achieves a 3-dB bandwidth of 150 MHz and a noise figure (NF) of 2.6-3.9 dB over the RX frequency range. Activating the parallel preselect filter degrades the NF by as little as 1.2 dB in the worst case. The RX shows a =97.5% throughput when receiving a 100MS/s quadrature phase shift keying (QPSK) signal with 7.5-dB SNR and achieves a -9.7 dB error vector magnitude (EVM) while facing a -15 dBm continuous-wave (CW) blocker only 20 MHz away from the desired 100-MS/s QPSK signal with 12.3-dB SNR, thus satisfying the 3rd generation partnership project (3GPP) requirements with sufficient margin.

【 授权许可】

Free