Improved Photocatalytic Properties of Bismuth Molybdate Prepared by using High Energy Ball Milling Technique for Degradation of Rhodamine B

Indian Journal of Pure & Applied Physics

article

Mangaraj Pradhan¹  Sanjeeb Kumar Rout¹  Shomaila Khanam¹ 

[1] Department of Physics, Birla Institute of Technology, Mesra, Ranchi

关键词: Photocatalysis;    Electron scavengers;    Photo-degradation;    Rhodamine B;    Article;   

来源: National Institute of Science Communication and Information Resources

【 摘 要 】

Bismuth molybdate (Bi2MoO6) was prepared through the solid-state route in the stoichiometric ratio followed by ball milling. The high-energy ball milling reduced the crystalline size from 96 to 35nm and increased the surface area from 0.351616 to10.7256 m²/g in 5h. No structural change was observed. The comparative study of the photo catalytic activity for the decolorization of Rhodamine B (RhB) in the presence of UV light has been done by employing 5h milled Bi2MoO6 and unmilled Bi2MoO6 as a catalyst has been done. The dye degradation was observed by a decrease in the absorption spectrum and decolorization in the presence of UV irradiation. The 5h milled Bi2MoO6 proved to be the efficient photocatalyst over unmilled Bi2MoO6. The degradation efficiency of the unmilled and 5h ball milled (Bi2MoO6) catalyst, observed in RhB was found to be 30 and 80% respectively. The degradation efficiency was found to be dependent on the size of the catalyst added in the dye solution may be due to increased surface area provided the increased number of active sites for the reaction. Therefore, 5h ball-milled Bi2MoO6 can act as a catalyst for the treatment of noxious and imperishable organic pollutants in water.

【 授权许可】

Unknown