Influence of voltage, feed speed and CTWD on the corrosion resistance of Inconel 625 alloy coatings deposited by MIG

Materia

article

Igor Jaloto de Lima¹  Beatriz Cândida de Farias Ferreira¹  Aureliano Xavier dos Santos¹  Theophilo Moura Maciel²  Renato Alexandre Costa de Santana² 

[1] Federal Rural University of Pernambuco;Federal University of Campina Grande

关键词: Steel;    Coating;    Inconel;    Corrosion;    MIG;   

DOI  :  10.1590/S1517-707620220002.1371

学科分类：工程和技术（综合）

来源: Universidade Federal do Rio de Janeiro * Coordenacao dos Programas de Pos-Graduacao de Engenharia

【 摘 要 】

Annually, high investments are made in the maintenance of pipelines used in the oil industry around the globe. Thus, solutions are sought that combine low cost, reproducibility and properties that are consistent, mainly against corrosion. One of these is the use of materials that have high mechanical and anticorrosive properties in the form of coatings, which could be deposited by welding. The objective of this study was to evaluate the effects of different welding parameters on the corrosion resistance of coatings based on the Inconel 625 alloy, deposited by metal inert gas welding metal (MIG) process in API 5L X70 steel. The parameters were optimized using the factorial experimental design and the results analyzed by the Response Surface Methodology (RSM). Three deposits with ½ overlap were performed MIG, followed by a cross section cut in the samples for analysis of the dilution, iron content and corrosion resistance by potentiodynamic polarization (PP) through corrosion potential (Ecorr), corrosion current (Icorr) and polarization resistance (Rp). The coatings obtained presented values of the dilution ranging from 5.8% to 15.01%. The coating that presented lower dilution value, also was the one with lower Icorr and Fe, besides higher Rp and Ecorr, thus, greater corrosion resistance.

【 授权许可】

CC BY