Comparison of experimental and finite element analysis results of a sheet metal prototype vehicle door hinge in X, Y and Z directions

Materia

article

Hande Güler Özgül¹  Onur Erol² 

[1] University of Uludag, Department of Automotive Engineering;University of Uludag

关键词: Finite element simulation;    UNECE R11 regulation;    Vehicle door hinge;    3D scan;    Cad model;   

DOI  :  10.1590/S1517-707620210003.13017

学科分类：工程和技术（综合）

来源: Universidade Federal do Rio de Janeiro * Coordenacao dos Programas de Pos-Graduacao de Engenharia

【 摘 要 】

In this study, the geometric differences which have a significant effect on the simulation results of the sheet metal prototype vehicle door hinge have been revealed. This geometric difference was examined by finite element simulations and experimental tests for the loads in the X, Y and Z directions specified in the UNECE R11 regulation.As a result, the curves of the finite element simulations and the experimental tests compared for each direction were examined and it was concluded that the compatible model with the experimental tests of the sheet metal prototype vehicle door hinge was 3D scan model.

【 授权许可】

CC BY