Numerical study of vortex rope during load rejection of a prototype pump-turbine

IOP Conference Series

article

J T Liu¹  S H Liu²  Y K Sun²  Y L Wu²  L Q Wang¹ 

[1] Institute of Chemical Process Machinery, Zhejiang University;State Key Laboratory of Hydroscience and Engineering, Tsinghua University

DOI  :  10.1088/1755-1315/15/3/032044

学科分类：材料科学（综合）

来源: Institute Of Physics Publishing

【 摘 要 】

A transient process of load rejection of a prototype pump-turbine was studied by three dimensional, unsteady simulations, as well as steady calculations.Dynamic mesh (DM) method and remeshing method were used to simulate the rotation of guide vanes and runner. The rotational speed of the runner was predicted by fluid couplingmethod. Both the transient calculation and steady calculation were performed based on turbulence model. Results show that steady calculation results have large error in the prediction of the external characteristics of the transient process. The runaway speed can reach 1.15 times the initial rotational speed during the transient process. The vortex rope occurs before the pump-turbine runs at zero moment point. Vortex rope has the same rotating direction with the runner. The vortex rope is separated into two parts as the flow rate decreases to 0. Pressure level decreases during the whole transient process.The transient simulation result were also compared and verified by experimental results. This computational method could be used in the fault diagnosis of transient operation, as well as the optimization of a transient process.

【 授权许可】

CC BY