Application of new sliding mode control in vector control of PMSM

IEICE Electronics Express

article

Hao Yang¹  Jing-Wei Tang²  Ying-Ren Chien³ 

[1] Anhui Technical College of Mechanical and Electrical Engineering;Hunan College of Information;Department of Electrical Engineering, National Ilan University

关键词: sliding mode observer (SMO);    new reaching law;    permanent magnet synchronous motor (PMSM);    vector control;    no position sensor Sliding mode control (SMC);   

DOI  :  10.1587/elex.19.20220156

学科分类：电子、光学、磁材料

来源: Denshi Jouhou Tsuushin Gakkai

【 摘 要 】

Aiming at the characteristics of low observation accuracy and high chattering of traditional sliding mode observers (SMO), a new SMO is proposed to reduce chattering and improve accuracy. In PMSM vector control, PI control has the problems of poor anti-disturbance ability and speed pulsation, while the traditional sliding mode control (SMC) has the problem of serious chattering, Therefore, on this basis, an SMC based on the new reaching law is designed, and the simulation is carried out in Matlab/Simulink. The simulation results show that the improved SMO has better performance and stronger stability than the traditional SMO. At the same time, compared with the traditional SMC and PI control, the SMC based on the new reaching law can make it respond well when the motor target speed changes suddenly, and effectively improve the problem of traditional SMC chattering, The control accuracy and steady-state error of the PMSM system are improved.

【 授权许可】

CC BY