Heat transport and magnetohydrodynamic hybrid micropolar ferrofluid flow over a non-linearly stretching sheet

AIMS Mathematics

article

Abdul Rauf¹  Nehad Ali Shah²  Aqsa Mushtaq¹  Thongchai Botmart³ 

[1] Department of Mathematics, Air University Multan Campus;Department of Mechanical Engineering, Sejong University;Department of Mathematics, Faculty of Science, Khon Kaen University

关键词: ferrofluid;    nonlinearly stretching sheet;    MHD flow;    hybrid nanofluid;    ferrohydrodynamic;   

DOI  :  10.3934/math.2023008

学科分类：地球科学(综合)

来源: AIMS Press

【 摘 要 】

A stable colloid called ferrofluid is made up of tiny magnetic particles, often magnetite (Fe 3 O 4 ), that have been bonded with an amphiphilic dispersion layer and are then suspended in a suitable liquid solvent carrier. Current industrial uses for ferrofluid include dynamic sealing, inertial and viscous damping, magnetic drug targeting, liquid microrobots, etc. In this article, we studied the heat transfer and MHD micropolar ferrofluid flow caused by non-linearly stretching surface. The results are presented for hybrid alumina- copper/ethylene glycol (${Al}_2 {O}_3$-Cu/EG) nanofluid. The governing non-linear equations describing flow are transformed into a system of ordinary differential equations using similarity transformations. Using the BVp4c method, the microstructure and inertial properties of a magnetite ferrofluid across a non-linear stretched sheet are studied. The influence of relevant parameters on stream function, velocity, micro-rotation velocity, and temperature are obtained and represented graphically. The computed results are original, and it has been observed that if we increase the magnetic parameter, the stream function and the velocity decrease, while the temperature and micro-rotation velocity increase. As the Prandtl number increases, the temperature profile decreases. It has been observed that the Nusselt number or heat transfer rate of hybrid nanofluid is better as compared to nanofluid flow.

【 授权许可】

CC BY