期刊论文详细信息
Applied Sciences
Efficiency of Machine Sanding of Wood
Kinga Stuper-Szablewska1  Tomasz Rogoziński2  Radosław Mirski3  Maciej Sydor4 
[1] Department of Chemistry, Faculty of Forestry and Wood Technology, Poznań University of Life Sciences, ul. Wojska Polskiego 38/42, 60-637 Poznań, Poland;Department of Furniture Design, Faculty of Forestry and Wood Technology, Poznań University of Life Sciences, ul. Wojska Polskiego 38/42, 60-637 Poznań, Poland;Department of Wood-Based Materials, Faculty of Forestry and Wood Technology, Poznań University of Life Sciences, ul. Wojska Polskiego 38/42, 60-637 Poznań, Poland;Department of Woodworking Machines and Fundamentals of Machine Design, Faculty of Forestry and Wood Technology, Poznań University of Life Sciences, ul. Wojska Polskiego 38/42, 60-637 Poznań, Poland;
关键词: softwood;    hardwood;    sanding;    belt sander;    sandpaper;    abrasion;   
DOI  :  10.3390/app11062860
来源: DOAJ
【 摘 要 】

We hypothesized that the type of wood, in combination with the grit size of sandpapers, would affect sanding efficiency. Fixed factors were used in the experiment (a belt sander with pressure p = 3828 Pa, and a belt speed of vs = 14.5 m/s) as well as variable factors (three sand belts (P60, P120, P180), six hardwood species (beech, oak, ash, hornbeam, alder, walnut) and three softwood species (pine, spruce, larch)). The masses of the test samples were measured until they were completely sanded. The sanding efficiency of hardwood species is less variable than for softwood species. Maximum sanding efficiency for the softwood ranged from 1 to 2 min, while for the hardwood species, it ranged from 2 to 4.5 min at the start of sanding and then decreased. The average time for complete sanding of the softwood samples was: 87 s (P60), 150 s (P120), and 188 s (P180). For hardwood, these times were 2.4, 1.5, and 1.8 times longer. The results indicate that the factors determining sanding efficiency are the type of wood, and, secondly, the grit size of sanding belts. In the first phase of blunting with the sanding belts, the sanding processes of hardwood and softwood are significantly different. In the second phase of blunting, sanding belts with higher grit numbers (P120 and P180) behaved similarly while sanding hardwood and softwood.

【 授权许可】

Unknown   

  文献评价指标  
  下载次数:0次 浏览次数:0次