期刊论文详细信息
Advances in Sciences and Technology
Effect of Nature and Amount of Polypropylene Composite Filler on the Productivity of Extruder with the Cylinder Equipped with Grooves
Janusz Sikora1  Tomasz Jachowicz1  Volodymyr Krasinskyi2  Oleh Suberlyak3  Volodymyr Moravskyi3 
[1] Lublin University of Technology, Mechanical Engineering Faculty, Department of Technology and Polymer Processing, ul. Nadbystrzycka 36, 20-618 Lublin, Poland;Lviv Polytechnic National University, Department of Chemical Technology and Plastics Processing, Bandera 12 St., 79013 Lviv, Ukraine;Lviv Polytechnic National University;
关键词: extrusion;    polypropylene;    filler;    extruder;    screw;    barrel design;    active grooved feed section;   
DOI  :  10.12913/22998624/114960
来源: DOAJ
【 摘 要 】

The effect of grooves number in the feed section and screw length as well as filler nature and content on the productivity of single-screw extruder has been examined. Compositions based on polypropylene with glass fibers, talc and chalk were used for research. It is established that the number of grooves in the feed section and the length of the screw differently affect the productivity of a single screw extruder depending on the nature and content of the filler. This effect is shown to be most significant for polypropylene compositions with mineral powders (talc and chalk).

【 授权许可】

Unknown   

  文献评价指标  
  下载次数:0次 浏览次数:0次