Improved Rotor Flux and Torque Control Based on the Third-Order Sliding Mode Scheme Applied to the Asynchronous Generator for the Single-Rotor Wind Turbine

Mathematics

Nicu Bizon¹  Habib Benbouhenni² 

[1] Faculty of Electronics, Communication and Computers, University of Pitesti, 110040 Pitesti, Romania;Faculty of Engineering and Architecture, Department of Electrical & Electronics Engineering, Nisantasi University, Istanbul 34481742, Turkey;

关键词: asynchronous generator;    single-rotor wind turbine;    direct flux and torque control (DFTC);    third-order sliding mode controller (TOSMC);    integral proportional (PI) regulator;    DFTC-PI control;   

DOI  :  10.3390/math9182297

来源: DOAJ

【 摘 要 】

In this work, a third-order sliding mode controller-based direct flux and torque control (DFTC-TOSMC) for an asynchronous generator (AG) based single-rotor wind turbine (SRWT) is proposed. The traditional direct flux and torque control (DFTC) technology or direct torque control (DTC) with integral proportional (PI) regulator (DFTC-PI) has been widely used in asynchronous generators in recent years due to its higher efficiency compared with the traditional DFTC switching strategy. At the same time, one of its main disadvantages is the significant ripples of magnetic flux and torque that are produced by the classical PI regulator. In order to solve these drawbacks, this work was designed to improve the strategy by removing these regulators. The designed strategy was based on replacing the PI regulators with a TOSMC method that will have the same inputs as these regulators. The numerical simulation was carried out in MATLAB software, and the results obtained can evaluate the effectiveness of the designed strategy relative to the traditional strategy.

【 授权许可】

Unknown