Calculation of the multi-blade rotary-friction tool's cutting cupped cutter to strength in the Ansys WB surrounding

Istrazivanja i projektovanja za privredu

Rakishev Asset¹  Tussupova Sayagul¹  Sherov Karibek¹  Smakova Nurgul¹  Imanbaev Yernat¹  Donenbaev Bakytzhan¹  Sagitov Almat¹  Mazdubay Asylkhan² 

[1] Karaganda State Technical University, Mechanical Engineering Faculty, Department "Technological equipment, mechanical engineering and standardization", Karaganda, Kazakhstan;Pavlodar State University, Mechanical Engineering Faculty, Department of Metallurgy, Pavlodar, Kazakhstan;

关键词: heating cupped cutter;    cutting cupped cutter;    strength;    stiffness;    cutting force;    radial displacement;    deformation;   

DOI  :  

来源: DOAJ

【 摘 要 】

The authors developed the design of a special multi-blade rotary-friction tool. The multi-blade rotary-friction tool is equipped with two cupped cutters - heating and cutting. The heating cupped cutter is made of medium-carbon structural steel of any brand, and the cutting cupped cutter is made of steel R6M5. The final formation of the treated surface and its quality is provided by the cutting cupped cutter. This article presents the results of the calculation of the strength of the cutting cupped cutter multi-blade rotary friction tool.As a result, the following were established: when processing steels 30HGSA cutting force components reach the maximum value than when processing materials 40HN2MA, St.45, and St.3c (calm); strength and rigidity of the cutting cupped cutter is sufficient for processing optimal cutting conditions: nsp = 1000 rpm; S = 0.42 mm/rot; t = 1.0 mm.

【 授权许可】

Unknown