Multi-response optimization of machining characteristics in ultrasonic machining of WC-Co composite through Taguchi method and grey-fuzzy logic

AIMS Materials Science

Jatinder Kumar¹  Ravi Pratap Singh¹  Jagesvar Verma²  Ravinder Kataria² 

[1] ¹ Department of Mechanical Engineering, National Institute of Technology, Kurukshetra, Haryana, India;² School of Mechanical Engineering, lovely Professional University, Jalandhar, Punjab, India;

关键词: composite;    grey-fuzzy;    machining;    optimization;    Taguchi;    USM;    WC-Co;   

DOI  :  10.3934/matersci.2018.1.75

来源: DOAJ

【 摘 要 】

This article addresses the application of grey based fuzzy logic coupled with Taguchi’s approach for optimization of multi performance characteristics in ultrasonic machining of WC-Co composite material. The Taguchi’s L-36 array has been employed to conduct the experimentation and also to observe the influence of different process variables (power rating, cobalt content, tool geometry, thickness of work piece, tool material, abrasive grit size) on machining characteristics. Grey relational fuzzy grade has been computed by converting the multiple responses, i.e., material removal rate and tool wear rate obtained from Taguchi’s approach into a single performance characteristic using grey based fuzzy logic. In addition, analysis of variance (ANOVA) has also been attempted in a view to identify the significant parameters. Results revealed grit size and power rating as leading parameters for optimization of multi performance characteristics. From the microstructure analysis, the mode of material deformation has been observed and the critical parameters (i.e., work material properties, grit size, and power rating) for the deformation mode have been established.

【 授权许可】

Unknown