Power Consumption and Calculation Requirement Analysis of AES for WSN IoT

Sensors

Wen-Ting Hsu¹  Chung-Wen Hung² 

[1] Technology, 123 University Road, Section 3, Douliou 64002, Yunlin, Taiwan;;Department of Electrical Engineering, National Yunlin University of Science &

关键词: power consumption;    Internet of Things (IoT);    Advanced Encryption Standard (AES);    Electronic Codebook Mode (ECB);    Counter with CBC-MAC (CCM);    Message Integrity Check (MIC);   

DOI  :  10.3390/s18061675

来源: DOAJ

【 摘 要 】

Because of the ubiquity of Internet of Things (IoT) devices, the power consumption and security of IoT systems have become very important issues. Advanced Encryption Standard (AES) is a block cipher algorithm is commonly used in IoT devices. In this paper, the power consumption and cryptographic calculation requirement for different payload lengths and AES encryption types are analyzed. These types include software-based AES-CB, hardware-based AES-ECB (Electronic Codebook Mode), and hardware-based AES-CCM (Counter with CBC-MAC Mode). The calculation requirement and power consumption for these AES encryption types are measured on the Texas Instruments LAUNCHXL-CC1310 platform. The experimental results show that the hardware-based AES performs better than the software-based AES in terms of power consumption and calculation cycle requirements. In addition, in terms of AES mode selection, the AES-CCM-MIC64 mode may be a better choice if the IoT device is considering security, encryption calculation requirement, and low power consumption at the same time. However, if the IoT device is pursuing lower power and the payload length is generally less than 16 bytes, then AES-ECB could be considered.

【 授权许可】

Unknown