STUDY THE BEHAVIOR OF ELASTIC MODULUS FOR ZIGZAG AND ARMCHAIR SINGLE WALL CARBON NANOTUBE STRUCTURE WITH FEM

Journal of Engineering and Sustainable Development

Qusay W. Ahmed¹  Dhia A. Alazawi²  Hussein B. Mohammed² 

[1] Civil Engineering Department, College of Engineering, University of Diyala, Diyala Iraq ;Mechanical Engineering Department, College of Engineering, University of Diyala, Diyala Iraq;

关键词: zigzag and armchair;    swcnts;    young’s modulus;    zigzag and armchair;    mechanical properties;    finite element analysis (fea);   

DOI  :  10.31272/jeasd.25.4.10

来源: DOAJ

【 摘 要 】

A three-dimensional finite element (FE) model for single-walled carbon nanotubes with armchair and zigzag shapes is proposed in this paper (SWCNTs). Nodes are positioned at the locations of carbon atoms to design the FE models. And three-dimensional elastic beam components are used to model the bonds between them. The effect of the diameter length/diameter ratio on the diameter length/diameter ratio, cross sectional aspect ratio and number of elements on the Young’s modulus of SWCNTs has been considered herein. From the conducted experiments it can be observed that, the larger tube diameter can lead to higher Young’s modulus for carbon nanotubes. Such that, maximum elastic modulus for the armchair and the zigzag models has be obtained to be 1.0285TPa and 1.0396TPa when the diameters for the armchair and the zigzag models were 2.034nm and 1.957nm respectively. Increasing the length/diameter ratio has led the Young’s modulus to be increased for armchair and zigzag models such that its values can reach 1.0451TPa and 1.0191TPa respectively. The cross sectional aspect ratio of SWCNTs showed an inversely proportional effect on the elastic modulus in this work. As a result of rising the cross sectional aspect ratio to be2, the Young's modulus for armchair and zigzag models has decreased to 0.7991TPa and 0.8873TPa, accordingly.The change in geometry has been observed to be a defect and it is in general can decrease the modulus of elasticity. The number of elements in the armchair model considered as prominent factor that increases the young’s modulus to be 1.0280TPa when the number of element is 10836. In zigzag model, the number of element has no effect on the elastic modulus since the number of nodes that exposed to the applied load is fixed in this case. The findings showed that the proposed FE model may be useful for studying carbon nanotube mechanical action in the future.

【 授权许可】

Unknown