Strength Tests and Numerical Simulations of Loess Modified by Desulfurization Ash and Fly Ash

Materials

Zhi Cheng¹  Xinrong Cheng¹  Zhe Ma¹  Yuhao Liu¹  Yuchao Xie² 

[1] School of Science, North University of China, Taiyuan 030051, China;Shanxi Road and Bridge Renewable Resources Development Co., Ltd., Taiyuan 030000, China;

关键词: desulfurization ash;    modified loess;    shear strength;    FLAC3D;    numerical simulation;   

DOI  :  10.3390/ma15020512

来源: DOAJ

【 摘 要 】

Desulfurization ash and fly ash are solid wastes discharged from boilers of power plants. Their utilization rate is low, especially desulfurization ash, most of which is stored. In order to realize their resource utilization, they are used to modify loess in this paper. Nine group compaction tests and 32 group direct shear tests are done in order to explore the influence law of desulfurization ash and fly ash on the strength of the loess. Meanwhile, FLAC3D software is used to numerically simulate the direct shear test, and the simulation results and the test results are compared and analyzed. The results show that, with the increase of desulfurization ash’s amount, the shear strength of the modified loess increases first and then decreases. The loess modified by the fly ash has the same law with that of the desulfurization ash. The best mass ratio of modified loess is 80:20. When the mass ratio is 80:20, the shear strength of loess modified by the desulfurization ash is 12.74% higher than that of the pure loess on average and the shear strength of loess modified by fly ash is 3.59% higher than that of the pure loess on average. The effect of the desulfurization ash on modifying the loess is better than that of the fly ash. When the mass ratio is 80:20, the shear strength of loess modified by the desulfurization ash is 9.15% higher than that of the fly ash on average. Comparing the results of the simulation calculation with the actual test results, the increase rate of the shear stress of the FLAC3D simulation is larger than that of the actual test, and the simulated shear strength is about 8.21% higher than the test shear strength.

【 授权许可】

Unknown