Physics-based and phenomenological plasticity models for thermomechanical simulation in laser powder bed fusion additive manufacturing: A comprehensive numerical comparison

Materials & Design

Patcharapit Promoppatum¹  Anthony D. Rollett² 

[1] Center for Lightweight Materials, Design, and Manufacturing, Department of Mechanical Engineering, Faculty of Engineering, King Mongkut's University of Technology, Thonburi, Bangkok, 10140, Thailand;Department of Materials Science and Engineering, Carnegie Mellon University, Pittsburgh, PA, 15213, USA;

关键词: Additive manufacturing;    Laser powder bed fusion;    Thermomechanical modeling;    Residual stress;    Ti-6Al-4V alloy;    Material constitutive models;   

DOI  :  

来源: DOAJ

【 摘 要 】

The present study investigated the sensitivity of material constitutive models on thermomechanical responses in laser powder bed fusion additive manufacturing of Ti-6Al-4V. Uniform scan strategies with scan lengths of 0.5, 1, and 2 mm were applied so that wide ranges of thermal histories could be generated. The Johnson-Cook (JC) and Mechanical Threshold Stress (MTS) material plasticity models were chosen to capture the influence of strain, strain rate, and temperature. The JC model is a phenomenological model which is known for its easy implementation and excellent agreement with material testing results. On the other hand, the MTS model is a more complex physics-based internal state variable plasticity model that is expected to provide more accurate estimation, particularly for cases involving changes in strain rate and temperature. Numerical results revealed that both JC and MTS models provided a similar stress evolution, however, the plastic strain evolution was more realistic using the MTS model. Moreover, it was found that the maximum strain and the strain rate in the LPBF process are high compared to typical quasi-static testing, i.e., ~ 2% and ~ 4 s−1, respectively. Accordingly, the material models should be calibrated with data obtained under similar deformation conditions. The choice of scan length also strongly affects in-plane stress anisotropy. Ultimately, we show both qualitatively and quantitatively the dependency of mechanical behavior prediction in LPBF on the choice of material models.

【 授权许可】

Unknown