Evaluation of Fe-Mg Binary Oxide for As (III) Adsorption—Synthesis, Characterization and Kinetic Modelling

Nanomaterials

Ameer Azam¹  Rumman Zaidi¹  IzharulHaq Farooqi²  SaifUllah Khan²  Feroz Shaik³  Faheem Ahmed⁴  Hatem Abuhimd⁵ 

[1] Department of Applied Physics, Zakir Husain College of Engineering & Technology, Aligarh Muslim University, Aligarh 202002, India;Department of Civil Engineering, Zakir Husain College of Engineering & Technology, Aligarh Muslim University, Aligarh 202002, India;Department of Mechanical Engineering, Prince Mohammad Bin Fahd University, P.O. Box 1664, Al Khobar 34754, Saudi Arabia;Department of Physics, College of Science, King Faisal University, P.O. Box 400, Hofuf, Al-Ahsa 31982, Saudi Arabia;National Nanotechnology Center, King Abdulaziz City for Science and Technology, P.O. Box 6086, Riyadh 11442, Saudi Arabia;

关键词: arsenic contamination;    nano-particle synthesis;    binary metal oxide;    co-existing ions;    adsorption mechanism;   

DOI  :  10.3390/nano11030805

来源: DOAJ

【 摘 要 】

Nanotechnology has received much attention in treating contaminated waters. In the present study, a facile co-precipitation method was employed to synthesize a novel iron and magnesium based binary metal oxide using a stoichiometrically fixed amount of FeNO₃.9H₂O and MgNO₃.6H₂O in a proportion of molar concentration 1:1 and was later evaluated in removing As (III) from contaminated waters. Characterization of the prepared nanomaterial was done using X-ray diffraction (XRD), scanning electron microscopy (SEM), Energy Dispersive X-Ray Analysis (EDAX) and ultraviolet–visible spectrophotometry (UV-VIS). Experimental studies on batch scale were carried out, examining the effect of varying initial concentrations of metal, adsorbent dosage, application time and initial pH on removal efficiency. Arsenic removal increased on increasing adsorbent dosage (0.1–1 g/L) but trend reversed on increasing initial arsenic concentration attaining q_max of 263.20 mg/g. Adsorption was quite efficient in pH range 4–8. Freundlich fitted better for adsorption isotherm along with following Pseudo-2nd order kinetics. The reusability and effect of co-existing ions on arsenic adsorption, namely SO₄²⁻, CO₃²⁻ and PO₄³⁻ were also explored with reusability in 1st and 2nd cycles attained adsorptive removal up to 77% and 64% respectively. The prepared nano-adsorbent showed promising results in terms of high arsenic uptake (q_max of 263.20 mg/g) along with facile and cost-effective synthesis. Thus, the co-precipitation technique used in this work is a simple one step procedure without any use of any precursor as compared to most of the other procedures used for synthesis.

【 授权许可】

Unknown